Re: A/C Troubleshooting

cjt wrote:
Eric in North TX wrote:
On Jun 26, 8:57 am, "IlBeBa...@xxxxxxxxx" <ilbeba...@xxxxxxxxx> wrote:

On Jun 26, 7:45 am, Eric in North TX <tine...@xxxxxxxxx> wrote:




On Jun 26, 7:30 am, "IlBeBa...@xxxxxxxxx" <ilbeba...@xxxxxxxxx> wrote:

On Jun 26, 7:03 am, Mike <mws...@xxxxxxx> wrote:

Last evening, my A/C unit stopped working. I'd like to try to figure
out what died, how much it will cost to fix, and if I can do the
repairs myself.

We heard a sort of buzzing sound a few times, and when I looked out
the window, I noticed that the fan blades seemed to be turning slower
than usual. I went to the thermostat and turned off the A/C for a few
minutes. When I turned it back on, I could hear a short buzz sound at
the A/C unit, but the fan blades didn't move. The buzz sound would
repeat every 10 seconds or so, but the fan never moved.

I then turned off the A/C and flipped the breaker. I tried to spin the
fan blades with a screwdriver, and they turn freely. I checked the
service disconnect box outside the house, and all looks fine.

I'm thinking that either the fan motor died, or the compressor is
dead, or both. Any thoughts?

The most likely cause is : a defective combo Run Capacitor based on
what youve described. You wont be able to buy this part yourself ; it
is only available thru the Trade and you need to initiate a Service
Call.

Exactly correct up till the last part, I used to buy nad replace my
own caps all the time. I upgraded all my units, so haven't had a break
down for a while,
My advise is to install two separate capacitors, anyhow. That way you
only have to replace the bad one, + the separate ones are easier to
find.
@ $10- $20 they are worth a try, that's less than 15 minutes worth of
service call.- Hide quoted text -

- Show quoted text -

You guys are encouraging a homeowner who hasnt had the technical
expertise to repair something he can destroy or hurt himself on. All
for the sake of a simple service call (??) . Whether he can get the
exact replacement or not, isnt the point. And to tell him to buy two
independent run capacitors and expect him to wire them in so they work
correctly and safely...is absurd im afraid. OP, call an HVAC
serviceman to do the job and realize your limitations ; at the same
time, he can check out the freon level, do preventive maintenance
routines, and tell you the overall performance of the entire system
including the inside Unit with Cooling Coil.


To a point I agree with you. I lose sight of the fact that a lot of
people lack the basic skills to even attempt such a task.
I was perhaps lucky, on my first attempt at AC repair, I peeled the
sheet metal on the outside unit and quickly spotted the problem.
That emboldened me to go deeper the next time. I do have fairly
advanced mechanical and electrical skills though, I have worked as a
auto dealer line mechanic, and the electrical I've picked up as I
went.
Having owned several older homes you just learn it, if you have more
desire to learn than money for service calls,
I have replaced nearly every component, over the years, on various
units, except a compressor, & for that I'd call a pro.

I dealt with thieving HVAC repairmen for years before becoming disgusted
enough to learn to do much of my own servicing. It's about the only
business I know where failure of a $20 part can result in a $2000 repair
bill. That said, there are limits to what one can do without equipment
that justifies a service call by someone who has it already.

Not everyone who repairs HVAC equipment is going to
rip you off. Just like all the trades, there are some
contractors who give the rest a bad name. I have to
defend the majority of "all" trades. Word will get
around pretty quick if you gouge people no matter
what service is provided.

TDD
.

Relevant Pages

  • Re: Furnace Failure...UGH!
    ... That's true about googling for repair parts and directions. ... Try and figure out why the fan failed. ... There is a local parts distributor for Modine that sells to the HVAC ... If I decide to fix the POS that I have now I would probably do that. ...
    (rec.gardens.orchids)
  • Re: cpu fan not detected
    ... If you have him show you where the crack is also look for and identify if ... each fan is running. ... for the repair you can get either a new or refurbished system from Dell. ... entirely sure what he is going to do exactly with the motherboard. ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Heat pump, fan on or auto?
    ... I mentioned my ridiculously high electric bill to the first repair man ... should leave the heat pump fan on ON all the time. ...
    (alt.home.repair)
  • FYI HP Call Centres
    ... sink fan). ... unbelievable that your brand HP does not support the customer. ... Finally when the Brand could not deliver I had to go out on my own to ... computers they have to be sent directly to HP for repair. ...
    (microsoft.public.windows.mediacenter)
  • Re: A/C Troubleshooting
    ... but the fan blades didn't move. ... all the HVAC and refrigeration repair techs are ... Chinese made start and run capacitors. ... the American manufactured capacitors are usually ...
    (alt.home.repair)