Re: Where can I find a 22" by 2" replacement floor grate for a sump pump?

mm wrote:
On Sat, 31 May 2008 14:53:45 -0400, "Robert Green"
<ROBERT_GREEN1963@xxxxxxxxx> wrote:


I'm installing a new sump pump that sits in a sump at the landing of my
basement stairs. The grate's at least 20 years old, has about a one inch
square pattern created out of square 1/4" steel stock. It has to be sturdy


Or why not just clean up this one? Use a wire brush for each hole to
get the loose stuff out. Then wire brush the two faces with a bench
grinder brush. Those two surfaces will look like new when youre done,
and the rest may look great too.

Twenty years is not much.


enough to stand on. I checked Home Depot, and two salesmen came up blank,
but that doesn't mean they don't sell them! (-:

Any suggestions on where else to look?

TIA,



POR-15 might help, too.

nate

--
replace "roosters" with "cox" to reply.
http://members.cox.net/njnagel
.

Relevant Pages