Re: very low voltage -- dangerous?

Floyd L. Davidson wrote:

John McGaw <nobody@xxxxxxxx> wrote:

Put a load on the circuit, turn off the breaker, then measure -- it will
almost certainly show you 0 volts as it should.


That is not necessarily true. A "load", could for
example be provided by switching on a few lights some
appliance plugged into that particular circuit.

It might, or might not, affect the voltage reading,
depending on the wiring between the "load" and the point
where a reading is taken.


If you see voltage under
these circumstances _then_ you have a problem of some sort. As others
have pointed out, you can not blindly rely upon a high-impedance meter
in home-wiring situations since they can measure capacitive leakage
across open contacts and between adjacent conductors.


It isn't "capacitive leakage", either across open
contacts or between adjacent conductors. It's
induction.

And note that regardless of the load, the amount of
induction is exactly the same. That is, the power
induced into a given circuit by another is not going to
change when the load is changed. It's just a matter of
E = I * R, and reducing the load means the current goes
up and the voltage goes down. Since the meter is
reading voltage, it show a lower reading.

Hey,
It is E = I * Z since it is AC circuit. Your formula is for DC circuit.
.

Relevant Pages

  • Tektronix 2235 Oscilloscope Troubles
    ... - Visually inspected the circuit boards for obvious component failures ... provide the proper voltage to turn on the CRT. ... Does this load current sound about right for the outputs of these supplies? ... overload condition somewhere in the HV supply which allowed it to operate ...
    (sci.electronics.repair)
  • Re: heat and more heat with heatsinks? what do you think?
    ... The idea was to keep the voltage regulators from drifting ... The worst was a drift of 5 volts in under 3 minutes while the best ... a tenth of a volt under no load or full load for several *days*, ... a complementary task was to make a circuit WORK with a wide ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: heat and more heat with heatsinks? what do you think?
    ... The idea was to keep the voltage regulators from drifting ... a tenth of a volt under no load or full load for several *days*, ... a complementary task was to make a circuit WORK with a wide ... It wasn't until I was pretty much out of the business of designing audio ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: .2 volts between neutral and ground
    ... > potential between the two, so, there shouldn't be a voltage ... hence the load on that circuit). ... 200mV is completely normal for a modest load. ... David William Botsch ...
    (sci.electronics.repair)
  • Re: Need EL34 grounded-grid curves
    ... soundcard into the amp. ... I reduced voltage and bias current about 7% ... There are 2 x EL34 and 28 SS devices in that circuit of yours. ... mutually coupled load from anode, collector or drain as you have with an ...
    (rec.audio.tubes)
Loading