Re: do I need to upgrade to 200 amp service?

On Oct 31, 9:21 am, "Edwin Pawlowski" <e...@xxxxxxxx> wrote:
<mattmeitz...@xxxxxxxxx> wrote in message

news:1193835618.193412.46490@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

This came out of another post I made, but is something I never really
considered. I currently have 100 amp service, with 7 blanks in my
electrical panel and will be adding 6 new circuits as I finish my
basement. Someone suggested upgrading to 200amp service. I don't
want to overload my existing capacity, but I figured I have a gas
water heater, gas clothes dryer, gas furnace, gas range, etc. The
only major electrical load I have is A/C in the summer (that I can
think of right now at least). Therefore, 200amp service had never
crossed my mind. Any suggestions/opinions? Also, if I did upgrade to
200 amp service, what is the cost and process? I assume that it
doesn't cost more to have 200amp service once you get it hooked up,
it's still the same rate per kWh, just that there's the potential to
use more, right? Thanks yet again!

More circuits does not necessarily mean you need the 200A. The best way to
find your actual use is, buy or borrow an Amprobe. This is a meter you
clamp around a wire to see what is being used. Turn on everything in the
house, including the AC, and see actual use. You can also add up what is
running individually but it is not always as accurate.

No, it does not cost more once installed. You need a new meter, new main
breaker, perhaps a new panel. My guess is that you don't need it unless you
are adding some big loads.

One other way to see roughly how many amps is to use your existing
Utility power usage meter.

Meters record KilloWatt hours so you need to do a simple calculation
to check out the power you are using now. So you need to do the
following when you have everything on.

Step 1) Take a meter reading ==> READINGONE
Step 2) Wait 10 mins
Step 3) Take another meter reading ==. READINGTWO

Amps = (READINGTWO - READINGONE) * 0.05

Best, Mike.
Best, Mike.


.

Relevant Pages

  • Re: on inertia
    ... Especially if one or both of the parties are incompetent retards and do things like not knowing the meter number of the meter they're supplying. ... I won't bore you with full details of the 5 month struggle I had with PowerGen when my blonde bimbo friend accidentally switched to them for her gas. ... PowerGen farm out meter reading to Meter Reading Services Ltd, who couldn't tell the difference between a metric meter and an Imperial one. ...
    (uk.finance)
  • Re: Dont read if you dislike long posts.
    ... gas meter, then both pipes go up in the ceiling. ... Also wrote down the current reading, ... on the bill that says "if you get a huge bill, ...
    (alt.sysadmin.recovery)
  • Re: Identify faucet stem brand/part name
    ... (There is a remote display outside for the semi-annual meter reading). ... if the water line fails between the street and your ... gas company takes responsibility for the gas line all the way to the ... dig up the lawn, sprinklers, side walk, shrubbery, etc. ...
    (alt.home.repair)
  • Re: Identify faucet stem brand/part name
    ... (There is a remote display outside for the semi-annual meter reading). ... wonder if and where an outside shut-off exists underneath my front lawn. ... if the water line fails between the street and your ... gas company takes responsibility for the gas line all the way to the gas ...
    (alt.home.repair)
  • Re: Another Thetford fridge prob ;)
    ... The needle is only to show the gas is alight and that is all. ... and 'well into the green' after the fridge has run ... the meter is a very simple item, a very low voltage moving coil meter, ... and the burner tube cleaning out, as crap from the flue will most likely ...
    (uk.rec.caravanning)
Loading