Re: Wrong Home Voltage

good luck sueing the power co. ,,if you really are.. my voltage was
going up and down constantly/slowly from about 109 to 128 one time and
it was the ground wire on the supply line from the pole had bad
connection. i noticed it when i could feel a fan changeing rpms/.. lucas

http://www.minibite.com/america/malone.htm

.

Relevant Pages

  • Re: Intensity and what else affects a single ligth beams temperature?
    ... now and the voltage now to compute the power now. ... you still measure or compute the current NOW and the voltage NOW. ... Then remove phi from the calculation and demonstate ... That is going to give 100 Watts at that instant in time. ...
    (sci.physics.relativity)
  • Re: Collins 32V-3 HF Transmitter NICE!!!
    ... I think Gary Schafer's analysis is basically correct but I have minor comments to add (in addition to my earlier post, also quoted below, claiming the 400+ peak output just could not be possible, but I think I was wrong about that). ... 60 watts of audio on that final tube will at best, double the _instantaneous_ input voltage, therefore power to 240 watts which you could only attempt to measure ... amplitude, the power at this instant is four times the unmodulated, or 400 ...
    (rec.radio.amateur.boatanchors)
  • Re: Power Inverters
    ... The "designer" copied the circuit ... When using a square wave or modified sinewave ... Newer power supplies have built-in power factor correction to make ... the slightly higher voltage won't matter. ...
    (comp.sys.laptops)
  • Re: AC power measurement
    ... voltage and current will give the power dissipated. ... A simple way for mains powered devices is to measure the ... RMS current and multiply by the nominal/actual RMS voltage. ...
    (uk.comp.homebuilt)
  • Re: AC power measurement
    ... voltage and current will give the power dissipated. ... RMS current and multiply by the nominal/actual RMS voltage. ... Metrawatt analogue wattmeter using 'simple' analogue multiplier ...
    (uk.comp.homebuilt)