Re: Bathroom vanity light height/ new install



On Jun 21, 10:59 pm, "Mark" <m...@xxxxxxxxxxxx> wrote:
If you are doing a complete remodel, and have the space, you might consider
lights on the sides of the mirror rather than over the top. I personally
think this gives better light, with less shadows on your face while shaving
and for the little lady when she puts on her makeup.

"Mikepier" <mikep...@xxxxxxxxxxxxx> wrote in message


Thanks for the inputs. Unfortunately the vanity is against a wall so I
can't put lights on the side.
The vanity (30"W x 19"D) along with the medicine cabinet (30"H X 24"W)
is arriving Monday, so I think I'll wait until I get them so I can see
what I am dealing with, plus I will have a better idea what kind of
vanity light would match. I can't believe how many choices in lights
are out there. And all different sizes. Some are only 4" tall, others
are up to 11" ( sconces), plus the ceiling drops 8" not too far from
where the light will be, so I have to be careful where I mount the
box. If I mount it too low, the mirror will end up hitting the light.
If I mount it too high, the ceiling drop might be in the way.

.



Relevant Pages

  • Re: Fujis DSLR killer
    ... mount prohibits any protrusion of the lens behind mount; ... front of the sensor and would foul the rear lens element. ... secondary mirror is invented. ...
    (rec.photo.digital)
  • Re: password recovery in RAID1
    ... boot cdrom -s ... mount my secondary device /a ... (add a password to root) ... mirror, however other mirror shall be intact. ...
    (SunManagers)
  • Re: tak quality SCT?
    ... >>I looked through an AP Mak Cas once. ... So did an excellent Tak Mewlon. ... mirror finishing would be my interest. ... to me the mount is the most important part. ...
    (sci.astro.amateur)
  • Re: No new semiprofessional Nikon DSLR for now?
    ... Nikon's mount and mirror won't allow a 24x36mm 35mm film sized sensor. ... The full-frame Canons aren't exactly flying off the shelves, ...
    (rec.photo.digital.slr-systems)
  • Re: Mirror Mount Question
    ... Unfortunately, I already have a few kinematics mounts but, as I mentioned in ... these aren't ideal if you only want to move the mirror in one plane - ... My "three screws in a triangle" comment is a mount has the spring-loaded ...
    (sci.optics)

Loading