Can I use a diamond hole saw on wood?

I need to cut a 3/4" hole in a piece of engineered flooring. The hole needs
to have very clean and sharp edges.

Harbor Freight sells a diamond hole saw set for 6.99 (# 32399). Will a
diamond hole saw make clean cuts in wood, or will it chew up the edges of
the hole?

Is there anything that would work better than a diamond hole saw? An auger
bit or a Forstner bit?

Thanks

--
Walter
www.rationality.net
-


.

Relevant Pages

  • Re: Finished my first movement
    ... Not sure I understand about the needle in the hole, ... I cleaned out the jewels with pegwood fine, ... used a sewing needle to poke through to make sure the jewel was clean ... At first the watch would not run. ...
    (alt.horology)
  • Oil Dipstick Difficult to Remove
    ... I wound up pulling the cap off my digital dip stick. ... The hole looked nice and clean, but just to make sure I ... engine vent that has become clogged and, therefore, created difficulties in ...
    (rec.motorcycles.harley)
  • Re: How to open this cleanout?
    ... Third link shows clean out on the left with letters 'C.O.'.If that is ... original marking it could mean "clean out", so concentrating on that ... A diamond hole saw from  Harbor Freight ... A 1" diamond hole saw might work best, ...
    (alt.home.repair)
  • Re: Furnace problems. Again!
    ... I'm then going to pull and clean ... I'd also pay attention to the location of the spark ... some propane through, but you might not be getting enough. ... hole has accumulated crud compressed air usually won't clean it. ...
    (rec.outdoors.rv-travel)
  • A diamond hole saw for wood?
    ... I need to cut a 3/4" hole in a piece of finished hardwood. ... have very clean and sharp edges. ... Is there anything that would work better than a diamond hole saw? ...
    (rec.woodworking)