Ceiling fan control switch

Hi,
I would like to install a ceiling fan control switch that uses two
separate switches for control of fan speed and light kit.
The current installation has the fan and light kit on a single on/off
wall switch and uses manual chain controls.
The wall box has 3 wires: black (hot), neutral and a ground (a bare
copper wire).

In the instructions for the new wall switch it appears that an
additional (hot) wire is required for the separate control of the fan
and light.

Is there a way to perform the install using current 3-wire (black,
white, ground) installation?



Thank you All,
-Tom

.

Relevant Pages

  • Re: Ceiling fan control switch
    ... I would like to install a ceiling fan control switch that uses two ...
    (alt.home.repair)
  • Re: 3-way switches to ceiling fan and light?
    ... light so that the fan and light are controlled separately -- and both ... control the ceiling fan and light individually from a set of switches ... except that in this case I would like the switch sets to be ...
    (alt.home.repair)
  • Re: 3-way switches to ceiling fan and light?
    ... The room has two doorways and I would like to be able to control the ceiling ... fan and light individually from a set of switches located near each of the ... would like the switch sets to be able to control the ceiling fan and ceiling ...
    (alt.home.repair)
  • Re: Two devices, only a single electrical box
    ... the light switch is in a single gang electrical box. ... switch seperately controls the ceiling fixture and ceiling fan. ... to install a fan control. ... allow ZWave to dim the lights, and manually control a fan. ...
    (alt.home.repair)
  • Re: Furnace Fan Wont Stop Running!
    ... she can find the control, she may find an adjustment on it that was touched ... off the electric switch to the furnace. ... but it seems to me the furnace fan should be ...
    (alt.home.repair)