Re: 26-inch wide door?


"Edwin Pawlowski" <esp@xxxxxxxx> wrote in message
news:_855g.468$zR3.250@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx

"John" <noone@xxxxxxxx> wrote in message
news:69GdndZ2OeXYRMnZRVn-rA@xxxxxxxxxxxxxx
Looking for a 6-panel 26" wide door, 76 inches tall. I seem to only be
able to find either 24 or 28 inch wide doors but the original door and
the
current opening with original casing/trim is 26 inches.
Anyone know where I can find one? I don't need oak or anything like
that,
simple pine would do.

--
John

Buy a 28' and a saw. you can probably order one, but it may cost
considerably more than standard sizes.

'Standard' size /= 'the sizes the borg carries'. Call around to the real
lumber yards, and ask them to check their catalogs.

Just looking for a slab door, or a prehung? If you buy a predrilled blank
and cut it down, the knob hole will be wrong, and of course you have to get
the taper on the edge correct. And the door will still look just a little
'off', since the side rails will look skinny compared to the other doors.

If you are trying to match other doors in the house, pictures and an
in-person visit work better than a phone call.

aem sends...

.

Relevant Pages

  • Smoker door warpage.
    ... Hey, all, I looked at several articles regarding steel warpage with ... welding and cutting and some on hot-rolled versus cold-rolled steel ... smoker when the doors are cut and when the strap is ... What I did is I took a piece of 24 inch steel pipe (1/4 inch wall, ...
    (rec.crafts.metalworking)
  • Re: Smoker door warpage.
    ... The Brinkman unit uses rolled panels for the doors, ... smoker when the doors are cut and when the strap is ... What I did is I took a piece of 24 inch steel pipe (1/4 inch wall, ... two doors and maybe took an hour to weld them up fully (I didn't time ...
    (rec.crafts.metalworking)
  • Re: garage door
    ... I am going to do the same thing, build my own doors. ... to replicate the rail and stile joints however and build a nice panel door. ... The rail and stile joints are done using a 1/2 inch cove ...
    (rec.woodworking)
  • Re: Smoker door warpage.
    ... The Brinkman unit uses rolled panels for the doors, ... smoker when the doors are cut and when the strap is ... not sure if it's hot or cold rolled) and capped it with 1/4 inch plate ... I then applied 1 1/4 inch wide, 1/8th inch thick strap ...
    (rec.crafts.metalworking)
  • How to: create a list of objects?
    ... Car - Chevy - 4 doors, green paint ... Ford - 2 doors, purple paint ... Bike - 26 inch, green ...
    (comp.lang.java.programmer)