Re: Installing additional light fixtures in garage


"realeyz" <no@xxxxxxxxxxxx> wrote in message
news:pEbrf.320237$Cq1.317339@xxxxxxxxxxxxxxxxxxxxxxxxx
> OK sorry guys - here is a better illustration of the particular part
> of the circuit before and after - you can see the 2 additional
> fixtures on the right in the second pic basically nut'd into the
> first set of lights:

Yes they are correct for a circuit that is fed hot at the switch if that is
what you have.
Just nut one light to the next in a way that makes sense for your particular
rooom layout. Be sure to match the wire gauge with what you have 12 or 14.
Kevin


>
> http://www.realeyz.com/misc/lights_2.jpg
>
> [img:794a92de4c]http://www.realeyz.com/misc/lights_4.jpg[/img:794a92de4c]
>
> Is this correct? Thanx for the help.
>
> Happy Holidays!!
>


.

Relevant Pages

  • Re: duplicate nav lights panel
    ... You could always replace the in cabin switches with manual/remote ... breakers and place the circuit breaker control switches out in ... find except from specialized aviation or industrial control sources. ... It's perfectly acceptable to run the NAV lights ...
    (rec.boats.cruising)
  • Re: TV on a dimmer switch?!?
    ... The owner had a "certified" electrician install several light racks to ... this bozo electrician found the nearest circuit and tapped into it. ... he took an entire 50' wall and put it on one dimmer. ... > when the lights were dimmed. ...
    (sci.electronics.repair)
  • Re: No 12V Power in Rockwood Pop-up
    ... the fuse in the converter for the "lights" ... circuit blows every time I hook up the 110VAC. ... Confirmed continuity on the inline fuse up by the battery. ... Look closely at the bulb base. ...
    (rec.outdoors.rv-travel)
  • Re: Tech: Transistors, need someone much smarter than me
    ... but the lights stay lit all the time. ... I would like these light to dim with the GI circuit to complete the ... that turns on and off the 12 volts, but how do I tell a transistor to ...
    (rec.games.pinball)
  • Re: 120 to 12v conversion
    ... The existing lights are on a dedicated circuit. ... mount the low voltages power supply at the breaker panel and use the ... The circuit draws olny about 400ma of current on the 12v side so I ... supplies smoke without tripping a 15 amp breaker. ...
    (alt.home.repair)