Hot tub electiral problem.



I have a Sundance Cameo hot tub 1997 model and have an electrical
problem. The small circulation pump started to trip the GFI main
breaker. With the pump disconnected the breaker works fine and dosn't
trip. So I replaced the pump with a new one the exact same model pump
with same ratings and it still trips the breaker after about 15 to 30
seconds? I can trouble shoot and repair electrical systems but have no
information on the Sundance tub other then a small block diagram inside
the main electrical box. I'm at a loss as what to try next and would
appreciate any help if someone out there knows about Sundance hot tubs.
Mine has a model 850 main control board.

Thank You

.



Relevant Pages

  • Re: Hot Tub Motor Rating for Amperage
    ... (This is the GFCI breaker that I asked about yesterday when I wanted ... the wall switch again and the tub powers up and runs fine. ... uses he has to let everything "rest" before the initial trip will ...
    (alt.home.repair)
  • Re: Hot Tub Motor Rating for Amperage
    ... (This is the GFCI breaker that I asked about yesterday when I wanted ... the wall switch again and the tub powers up and runs fine. ... uses he has to let everything "rest" before the initial trip will ...
    (alt.home.repair)
  • Re: Hot Tub Motor Rating for Amperage
    ... (This is the GFCI breaker that I asked about yesterday when I wanted ... the wall switch again and the tub powers up and runs fine. ... uses he has to let everything "rest" before the initial trip will ... On the tub motor there is one label that gives the voltage and ...
    (alt.home.repair)
  • Re: Hot Tub Motor Rating for Amperage
    ... He goes to the basement, resets the breaker, flips ... the wall switch again and the tub powers up and runs fine. ... uses he has to let everything "rest" before the initial trip will ... *The manufacturer requires a 30 amp circuit. ...
    (alt.home.repair)
  • Re: Circuit Breaker Problem
    ... If your tub has a 240V heater and/or pump, ... The hot wires are the _output_ of the breaker. ...
    (alt.home.repair)