Welding Thin Copper

Hi. I am wanting to get into welding, and I have a question for those
who may know. What kind of welder would be used to make a vent like
this http://oldworlddistributors.com/pix_louvered_dryer_vent.html.
Thanks

.

Relevant Pages

  • Re: Miller 212 vs 252
    ... In addition my son plans to take welding when he starts ... carts instead of bringing me a welder. ... Now I'm really down to deciding if the Miller 252 is worth the extra ... I plan to just buy a bunch of scrap aluminum to learn on ...
    (sci.engr.joining.welding)
  • Re: Harbor Freight Tig
    ... I am new to welding & have used a mig welder from Harbor Freight ... I'm not a TIG welder, so I can only give you the basic items ... aluminum with that welder because it seems to be a DC-only machine, ...
    (sci.engr.joining.welding)
  • Re: Strange control problem -- SOLVED!!! -- 3 phase "firing system"
    ... and the plus side of the shunt. ... the old shunt in the welder, which was connected to the current meter ... to provide some hope of control stability while welding. ... voltage sensing is done right off the copper ...
    (sci.electronics.design)
  • Re: Who other than Lincoln and miller make an AC/DC inverterwith a capacity around 200 amps?
    ... Do you have a gas torch? ... - propane less expensive than special welding gases ... TIG capability, gas welding might work for you on those rare occasions ... >>>the machine too often to have a transformer based welder. ...
    (sci.engr.joining.welding)
  • Re: Arc Welders
    ... I need to do some light duty welding and have considered a wire feed ... of days (I had mates who could weld to watch). ... bit extra on top of the welder) - a small bottle will last ... I could have done that job with 5 welding rods (a cost of 75 ...
    (alt.home.repair)