Re: Glued in bolts okay for concrete?
On Mon, 31 Oct 2005 01:03:37 GMT, "Toller" <Toller@xxxxxxxxx> wrote:
....
>Well it is Sunday night, with no stores open, and I just can't leave thing
>undone; so I figured I would make do with what I had. I drilled a 3" hole
>through the bottom plate and into the floor. I mixed up some laminating
>epoxy, poured some down the hole and coated a 3" bolt. Then I hammered the
>bolt down.
....
just fine. the stress is sideways on these bolts and they would
hold even if they weren't glued. naturally, solid is better tho.
i think the pros use a nail gun, or srill holes and bang a
concrete nail in. i'd be awful surprised if anybody
actually used bolts.
....thehick
.
Relevant Pages
- Re: How to Drill Out a Broken Bolt?
... The most important thing is to try very hard to drill down the center ... the bolt so getting off center will be a big problem. ... tend to spread the bolt material out further jaming it in the hole. ... :the other two broken bolts using the Dremel tool. ...
(rec.boats) - Re: Not quite model engineering but worth a try...
... drills to show for it when they bite/grab at the bottom of the hole. ... hole, the nut's off and the protruding bolt been cut, as I read it. ... I'd second the thing about heat, and the one about the kango hammer is worth ... solid support around the bolt head (a bit of VERY ...
(uk.rec.models.engineering) - Re: Indiana Jones w/ NOS playfield installed (pics)
... I've seen this game and the ONLY thing that isn't total perfection is the ... hole with the bolt and even that is a perfect hole without any scratching or ... > I filled with a door bolt. ... > Backbox jackpot lighting ...
(rec.games.pinball) - Re: Masonry Fixings
... I thought that anything that cuts its own thread in brick is prone to ... You just drill a 8mm hole via one of the bracket mounting holes and screw ... Insert the first bolt then tighten it. ...
(uk.tech.digital-tv) - Re: Punched a hole in my gas tank last night
... whose head will just go thru the hole -- or enlarge the hole suitably. ... Cut a screwdriver slot in the other end of the bolt, ... Put short bit of square-cut fuel line on threaded part, ...
(rec.crafts.metalworking) |
|
