Re: Kenmore Elite moisture control board is bad


"dajoe" <dajoe13@xxxxxxxx> wrote in message
news:1124510488.439803.15700@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>I just took apart my 4.5 year old dry that was completely dead and I
> found the control board to have a blown transistor and a burnt
> resistor. Has anyone seen this before? What is the best way to repair
> this? Can I by a 5 cent transistor and 1 cent resistor and replace
> them ;-) or do I have to buy a new board. Does anyone know the
> transistor part numbers on this board?
>
> Regards,
> dajoe
>

Replace the transistor with a tube. These transistor things are just a fad.


.

Relevant Pages

  • Re: About some parts on logical circuits
    ... chance on some pushbutton switch logic? ... I wasn't aware of the pull-down resistor issue. ... Since each transistor will have to feed a dozen of LEDs at 40mA ... Run the LEDs off the transistor's collector. ...
    (alt.guitar.amps)
  • Re: astable multivibrator issues - 2N3904s work, but not TIP31As
    ... the circuit would not oscillate unless I briefly disconnected then re- ... The main issue folks have is that they forget to bypass the power supply, ... As a side note, the easy way to build a square wave oscillator from a cmos 555 is to connect the output pin to a resistor, then connect the other side of the resistor to ground through a capacitor. ... For your application, you might use the discharge to directly drive one LED, and have the other LED driven by a power PMOS or PNP transistor. ...
    (sci.electronics.basics)
  • Re: Switching +/-12V from 6/0V
    ... total current through the 1K emitter resistor. ... > collector and emitter. ... It's the transistor that drops the rest of the voltage. ...
    (sci.electronics.design)
  • Re: choosing a suitable transistor
    ... Will this transistor work instead: ... be able to do your own calculations of resistor values. ... If very short switching times are required, ...
    (sci.electronics.basics)
  • Re: Simple mosfet question
    ... The gate is tied directly to the input. ... a resistor, 10k, and the other side of the 10k resistor is tied to a ... better protect the transistor? ... to protect the transistor. ...
    (sci.electronics.design)
Loading