Re: DC power supply goes wonky


"DS" <rps@xxxxxxxxxxx> wrote in message
news:rtIJe.6453$p5.4039@xxxxxxxxxxxxxxx!nnrp1.uunet.ca...
>I have a 12 volt power supply that converts 110AC to
>12V DC (actually 13.5.)
> I haven't used it for some time.
> I was using it to check some wiring and find it is
> now putting out 21 VDC.
> ???
> ds
>

Is there a question there? Sounds like a rectifier
blew.

>
> --
> THE WORLD WILL ENDed Last NIGHT AT 9 O'CLOCK!
> (9:30 in Newfoundland.)
>


.

Relevant Pages

  • DC power supply goes wonky
    ... I was using it to check some wiring and find it is now putting out 21 VDC. ... (9:30 in Newfoundland.) ... Prev by Date: ...
    (alt.home.repair)
  • DC power supply goes wonky
    ... I was using it to check some wiring and find it is now putting out 21 VDC. ... (9:30 in Newfoundland.) ... Prev by Date: ...
    (sci.electronics.repair)
  • Cheap B+ boost
    ... the B+ at about 320 VDC was too low for cathode biased ... 6L6 output tubes with a 5U4 rectifier. ... I needed a cheap B+ boost rather than a new PT! ... I boosted the B+ by adding a scrap 30 VAC 1/2 amp mains transformer ...
    (rec.audio.tubes)
  • Re: Feature Lamp Help
    ... Check BR1 on the transformer. ... You should get around 6 VDC on test ... rectifier board TP1 test point. ... Measure 5 VDC at lamp driver TP1, and use lamp driver TP2 for ground. ...
    (rec.games.pinball)
  • FA: switch mode power supply single board
    ... switch mode power supply single board 15 VDC 4amps ... Rick Gaff NIRA1 ... Prev by Date: ...
    (sci.electronics.misc)