Wiring help needed

I have a Hohner G3T. It is two single coil pickups with a humbucker in
the bridge (like a HSS Strat). The humbucker can be split via
pull/push tone knob. Also, each pickup has a mini switch so they can
be turned on or off at will and in any combination (pretty versatile
actually).
My question is this....I want to eliminate the tone knob altogether.
The humbucker would be left in full bucker mode only.
Is there an easy way to disconnect it without major surgery (very
tight work area, my fat fingers don't do well in the cavity of this
one).
Thanks.

****
http://www.soundclick.com/bands/default.cfm?bandID=789610
.

Relevant Pages

  • Re: Pifckup question?
    ... Most guitars these days that have 2 or more single coil pickups have ... one that is reverse wound to cancel hum. ... using them as a humbucker. ...
    (alt.guitar.amps)
  • Re: Wiring help needed
    ... each pickup has a mini switch so they can be turned on ... My question is this....I want to eliminate the tone knob altogether. ... humbucker would be left in full bucker mode only. ... probably closed when the bucker is in bucker mode. ...
    (alt.guitar)
  • Re: Wiring help needed
    ... each pickup has a mini switch so they can ... My question is this....I want to eliminate the tone knob altogether. ... The humbucker would be left in full bucker mode only. ...
    (alt.guitar)
  • Re: Wiring help needed
    ... each pickup has a mini switch so they can ... My question is this....I want to eliminate the tone knob altogether. ... The humbucker would be left in full bucker mode only. ...
    (alt.guitar)
  • Re: Wiring help needed
    ... My question is this....I want to eliminate the tone knob altogether. ... humbucker would be left in full bucker mode only. ... probably closed when the bucker is in bucker mode. ... I suggest leaving wires at length, and putting a bit of shrink tube over each wire, in case you want to "restore" to stock. ...
    (alt.guitar)