Re: On to the preamp tubes


"Michael Zentner" <zentman(ns)@hotmail.com> wrote in message
news:49CdnbrZSvPkvcLbnZ2dnUVZ_s6onZ2d@xxxxxxxxxxxxxx
Hope you got it, sent it a few hours ago. Let me know about the preamp
thing if you will. Thanks



I got it Michael. I haven't looked to hard at it yet but that amp is packed
full of CMOS and transistors. It's a fairly complexed hybrid. You can safely
use a 12AT7 in place of 12ax7.

BH


.

Relevant Pages

  • Re: Prototype "tube-like" solid-state amp circuit
    ... or so in power - and I want it to sound good. ... you can't just swap a transistor for a tube. ... decided to do was use the transistors in Sziklai or Darlington pairs, ... worse than a typical pentode amp without feedback. ...
    (alt.guitar.amps)
  • Re: Heath AA-1600 amplifier problem
    ... I'm trying to fix an old Heath amp, ... I replaced the transistors with MJ15022/MJ15023 pairs. ... delivered 40W each without a problem before the mains voltage dropped too ... connection in one. ...
    (sci.electronics.repair)
  • Re: blown output transistors
    ... I've checked all of the driver transistors inasmuch as is possible ... I've checked all of the diodes and resistors ... I can power up the amp with output transistors removed, ... The new output transistors are NOT fried, ...
    (sci.electronics.repair)
  • Heath AA-1600 amplifier problem
    ... I'm trying to fix an old Heath amp, ... I replaced the transistors with MJ15022/MJ15023 pairs. ... Of course, the supply voltage dropped when I applied a load on the output, ... delivered 40W each without a problem before the mains voltage dropped too ...
    (sci.electronics.repair)
  • Re: Heath AA-1600 amplifier problem
    ... I'm trying to fix an old Heath amp, ... I replaced the transistors with MJ15022/MJ15023 pairs. ... Of course, the supply voltage dropped when I applied a load on the output, ... delivered 40W each without a problem before the mains voltage dropped too ...
    (sci.electronics.repair)