Re: Yet another ohm question


crow wrote:
> A DMM set to "ohms" across the terminals will give you the DC resistance of
> the voice coil. Multiply this by 1.25 for ohms.
>
> jepp
>

WHAT?!?!?!

.

Relevant Pages

  • Re: Whats my amp putting out ???
    ... >>> I would think it'd be more likely that his voice coil is 1.5 ohms. ... Speakers are always measured in Impedance never resistance. ...
    (rec.audio.car)
  • Re: 86 560SL no ignition spark???
    ... I will take the coil into work to check the resistance from pos to neg. ... It won't clearly resolve 3 ohms. ... terminals or in contact with one. ...
    (alt.auto.mercedes)
  • Re: Whats my amp putting out ???
    ... >> I would think it'd be more likely that his voice coil is 1.5 ohms. ... Speakers are always measured in Impedance never resistance. ...
    (rec.audio.car)
  • Re: Speaking of audiophools
    ... much as 100 ohms. ... resonance frequencyand especially the Q at the resonance, ... If an amp has a "damping factor" of 400, it means its interiour resistance ... This means that the resistance of the voice coil ...
    (sci.electronics.design)
  • Re: A/C Compressor coil burnt up?
    ... > The resistance between the C and R terminals is 2 ohms. ... > take it this means my run cap is not shorted. ... Did you measure S-R at the compressor terminals (removing any protective ...
    (sci.electronics.repair)