Re: PCB repair?
"Phil S." <psymonds@xxxxxxxxxxx> wrote
People that pack poorly should be shot.
*After* torture.
....
Do I attempt to expoxy the board or do I discard the bit of board that is
on the front pot?
Desolder and discard the bit of board. Scrape the traces and
tin about 1/4" of them... use thin stranded wire to jump to
the pot terminals. Don't drill any holes.
Make sure that dumsht seller gives you a %90 refund
before doing any of this... or send it back and make
him eat it, piece by piece, on YT... and send us the link.
__
Steve
..
.
Relevant Pages
- Re: Question re an 1881 Monmouth address
... The Forge, Monmouth, FHL Film 1342259, PRO Ref RG1, Piece 5228 Folio ... Iron plates rolled out then dipped in tin ... Doubling and rolling were performed three or four times, after which the plates were passed to the shearer who marked and cut them. ... The sheets, after being removed from the water bosh, were placed in the tinman's pot of melted grease, then in the tin pot containing melted tin covered with a layer of melted grease, from which they were taken to the wash-pot, which had two compartments. ...
(soc.genealogy.britain) - Re: Melting Lead: Keeping the Good Slag and Trashing the Bad Slag
... dross is a mixture of metal oxides, typically those of lead, tin, and antimony. ... After your metal is well melted, you need to flux the pot by dropping a small ... Fluxing actually helps you keep the desirable tin content where it should be. ...
(rec.pyrotechnics) - Re: whats involved in re-tinning a steel pot?
... Electroplating may not be a preferred ... Electroplating tin is easy to do. ... is several times the surface area of a 30"-wide pot that is 24" deep. ... A base box refers to 112 sheets of tinplate ...
(rec.crafts.metalworking) - Re: whats involved in re-tinning a steel pot?
... A lot of places re-tin copper pots and pans. ... remember, melt the tin in the pan, wipe the tin around with cotton waste. ... The outer surfaces of the pot are protected with whiting to prevent the hot ...
(rec.crafts.metalworking) - Re: whats involved in re-tinning a steel pot?
... But the whisks etc. over the years beat the tin off on the ... To do the process itself you need to CLEAN the pot very well. ... Toss the pot in there to clean off and loose tin and to etch the steel and clean it. ...
(rec.crafts.metalworking) |
|
