Re: PT and OT not on spec
- From: JP <JP@xxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Fri, 30 May 2008 21:12:24 -0500
On Fri, 30 May 2008 19:36:21 -0500, "Stephen Cowell"
<scowell@xxxxxxxxxxxxx> wrote:
So you teaching English now SC? Hell Mulay will wind 'em one...
"JP" <JP@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:flj0441meuncb6esnfl9raugad5iaimppp@xxxxxxxxxx
On Fri, 30 May 2008 04:16:22 -0700 (PDT), ross <roscolbar@xxxxxxxxx>
wrote:
A Local Tranny winder made me OT and PT for plexi clone (schematicMercury Magnetics, Heyborer, Hammond
from hoffmanamp.com) I built. The Vs are way off (500 on EL34's plate)
and OT is mismatched as well: instead of 3.4 K it gives 2.5 K into 8
ohm load. I'm thinking to haul these wonders out and ( if ithere is a
power tube that can handle such values as noted here) use then in a
new amplifier. Q: Anyone know of an output tube that likes 500 B+ on
its plate while looking into (PP) a 2.5 Kohm load? To get the plexi
back on track are there any Tranny winders one would recommended?
He wants winders, not mfgrs... and you misspelled Heyboer.
Peter Dahl Co. in El Paso, TX does lots of this kind
of thing... it ain't cheap, at all.
__
Steve
.
.
- References:
- PT and OT not on spec
- From: ross
- Re: PT and OT not on spec
- From: JP
- Re: PT and OT not on spec
- From: Stephen Cowell
- PT and OT not on spec
- Prev by Date: Re: OT:Lezbos get thrown out of ballpark for smootching in front of kids...
- Next by Date: Re: Dialling In Tone
- Previous by thread: Re: PT and OT not on spec
- Next by thread: Re: PT and OT not on spec
- Index(es):
Relevant Pages
|
