Re: PT and OT not on spec
- From: JP <JP@xxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Fri, 30 May 2008 14:00:39 -0500
On Fri, 30 May 2008 04:16:22 -0700 (PDT), ross <roscolbar@xxxxxxxxx>
wrote:
A Local Tranny winder made me OT and PT for plexi clone (schematicMercury Magnetics, Heyborer, Hammond
from hoffmanamp.com) I built. The Vs are way off (500 on EL34's plate)
and OT is mismatched as well: instead of 3.4 K it gives 2.5 K into 8
ohm load. I'm thinking to haul these wonders out and ( if ithere is a
power tube that can handle such values as noted here) use then in a
new amplifier. Q: Anyone know of an output tube that likes 500 B+ on
its plate while looking into (PP) a 2.5 Kohm load? To get the plexi
back on track are there any Tranny winders one would recommended?
.
- Follow-Ups:
- Re: PT and OT not on spec
- From: Stephen Cowell
- Re: PT and OT not on spec
- References:
- PT and OT not on spec
- From: ross
- PT and OT not on spec
- Prev by Date: Re: Fender 75 output tubes replacement
- Next by Date: Re: OT:Lezbos get thrown out of ballpark for smootching in front of kids...
- Previous by thread: Re: PT and OT not on spec
- Next by thread: Re: PT and OT not on spec
- Index(es):
Relevant Pages
|
