Re: 59 deluxe...project



Mike Schway wrote: 
In article <D3%Ue.50093$Sj1.17030@okepread04>,
 Swack Daddy <someshit@xxxxxxx> wrote:


Cool thanks. No .1 600v cap then. Just straight to ground it is. also, I'll check the resistance, and ground it if it's a hum shield (infinite resistance to to all of the secondaries. If not I'll post what I find. 


Check the resistance to the primary as well, just to be sure.

--Mike

--------------------------------------------------------------------
Mike Schway | [Picture your favorite quote here] mschway@xxxxxxx |
--------------------------------------------------------------------
OK Here's the results....
I check resistance across the seconadries...
Orange to B+ CT - 1.3M Ohms
Orange Across Blue/Red (Bias) - 1.65M Ohms
Oraange across the rest of the wires was Infinite resitance (or OL). This would mean that the Orange is a hum elimainating Ground, or Cage Ground.

I also measured VAc (without a recitier tube in place. Or any other tube in place for that matter.Here's the results...

Orange to ground 72VAC
Bias to Ground 64VAC
B+ CT to grund 38 VAC
on rect socket to ground
pin 6 180VAC
pin 4 251VAC
pin 2 17VAC
pin 8 21 VAC

Also between the green wires (filiment tap) 7.1VAC
Greens to Ground - 15VAC.

Are these close to what I should be getting? I haven't measured acroos the hi and low Voltage pins on the rect socket. I'm a little nervous about roasting another PT.Thanks in Advance.
.

Relevant Pages

  • Re: 59 deluxe...project
    ... I'll check the resistance, and ground it if it's a hum shield (infinite resistance to to all of the secondaries. ... pin 6 180VAC ...
    (alt.guitar.amps)
  • Re: 59 deluxe...project
    ... and ground it if it's a hum shield (infinite ... >>>resistance to to all of the secondaries. ... > Oraange across the rest of the wires was Infinite resitance. ... > pin 6 180VAC ...
    (alt.guitar.amps)
  • Re: n00b question
    ... > When driving an LED from a pin, he says the port is in "current source ... > connected to a n channel MOSFET, he says the output is in "Voltage ... so much current - in effect, the internal resistance of the 8051 is ... With the MOSFET you have the opposite situation. ...
    (comp.arch.embedded)
  • Re: 59 deluxe...project
    ... also, I'll check the resistance, and ground it if it's a hum shield (infinite resistance to to all of the secondaries. ... pin 6 180VAC ... the HV legs will float and any readings to ground are meaningless. ...
    (alt.guitar.amps)
  • Re: Problem with National NC-57
    ... measurements at all tube sockets and every measurement ... The manual indicates a resistance reading of 380K ohms ... can't see how pin 6 should be 380K ohms. ... at the tube socket. ...
    (rec.radio.amateur.boatanchors)