Re: Bumping a Fender Hot Rod Deluxe or Blues Deluxe from 40 to 60 watts?



In article <431536D2.491F4FB5@xxxxxxxxxxx>,
Joey Goldstein <nospam@xxxxxxxxxxx> wrote:

> Can this be done?
> It probably requires a different transformer, right?
> It'd be nice to have the power/headroom of the DeVille's in a combo
> with a single 12" speaker.

IMO, it's way too expensive to mod your amp this way. Others have
detailed the costs (maybe $300 in parts, a lot of work, and you'll end
up with an amp which will be harder to resell). Besides, the difference
in clean headroom is only about 1.5 dB or so.

Try using a more efficient speaker. Weber California 12 ceramic is
danged loud. It'll set you back about $85 and you'll truly have an
upgrade any subsequent buyer will appreciate.

--Mike

--------------------------------------------------------------------
Mike Schway | [Picture your favorite quote here]
mschway@xxxxxxx |
--------------------------------------------------------------------
.



Relevant Pages

  • Re: Best valve config for bass
    ... in the 10 to 200 Hz range, and not of a fullrange amp; ... transformer will perform even better, if I'm not asking the blood out of it. ... > Iron is important, but also the number of turns. ... >> the trade" to improve OPT frequency response without using tons of ...
    (rec.audio.tubes)
  • Re: IDing a Fender Bassman to reverse mods
    ... >>>A variac is very useful for checking the impendance ratio of unknown ... A variac works just fine. ... >>>unknown power transformer, ... If I'm buildng an amp that requires 330 volts AC ...
    (rec.audio.tubes)
  • Re: Does the power supply limit the actual power of a tube amp?
    ... I rebias the amp (perhaps ... you'll blow your power transformer." ... ALL current from the power transformer's collective secondary windings, ... Any increase in current draw from ANY one of the secondaries, ...
    (alt.guitar.amps)
  • Re: Problems with custom amp...
    ... >Anyway, it's basically a 50 watt Fender Reverb, single channel style amp. ... >Bassman size output transformer, no choke, yada-yada. ... >power tranny center-tap not connected, ground side of screen supply filter ... >the underrated filter supply caps. ...
    (alt.guitar.amps)
  • Re: Best valve config for bass
    ... > transformer will perform even better, if I'm not asking the blood out of it. ... is exactly the same as with a UL amp using 2 x 6550. ... dozen output tubes. ... The dozen 6550 would make about 90 watts of pure class A though, ...
    (rec.audio.tubes)