Re: Fallout 3, rough on the console?



On May 14, 3:23 am, "luckyvic" <vsalvat...@xxxxxxxxxxx> wrote:
What are the cons of Fallout 3, freezing, glitches?
Should be installed on the HDD for better results?

---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 090513-0, 05/13/2009
Tested on: 5/14/2009 2:23:58 AM
avast! - copyright (c) 1988-2009 ALWIL Software.http://www.avast.com

I didn't have any problems until latley , If you constantly retry
missions on both sides to see the evil -good results I noticed
sometimes that will cause audio and framerate problems when you load
another save. I had some bad texture pop-in and outs , where the
texture would pop in then pop out instantly like a flickering bulb.
Not regualr texture pop-ins but flickering in and out constantly, so I
just reloaded my game and it was fine. I should install to HDD to
resolve this. I also have some audio problems where the sound effects
where very muffled , so reloaded my save and it was fixed. It could be
because I'm flipping in and out of older/newer saves to see what
happens when I choose both good and evil results. Saving to HDD should
resolve this. I noticed some parts of steel look better than the
wasteland , defintley some added lighting and texture quality. Broken
Steel is worth every penny though, love it.
.



Relevant Pages

  • Re: New build - halt on ACPI Controller
    ... on the hdd from a previous install attempt. ... landed up using the rear panel mains isolator switch to switch it off as ... The use of partition analysis and repair tools unearthed a further two ...
    (uk.comp.homebuilt)
  • Re: Xp install problem
    ... Anna wrote: ... I am attempting to install xp after fitting a new HDD following a "failure" of the old one. ... When I reach the point during the install where the "install devices" starts, I get the stop code 0x000000BE. ... If so, it would be worthwhile to remove the graphics card, ensure your onboard graphics capability is enabled and see if the install will succeed. ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Xp install problem
    ... I am attempting to install xp after fitting a new HDD following a ... When I reach the point during the install where the "install ... graphics/video card. ... You're certain all your connections & configuration of components ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Xp install problem
    ... I am attempting to install xp after fitting a new HDD following a "failure" of the old one. ... When I reach the point during the install where the "install devices" starts, I get the stop code 0x000000BE. ... If so, it would be worthwhile to remove the graphics card, ensure your onboard graphics capability is enabled and see if the install will succeed. ... You're certain all your connections & configuration of components including the new HDD are proper and your motherboard is properly seated? ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Installing new hard drives
    ... Hard disk cloning software, "x copy", I ... a "fresh" install and not be able to access the old drive to copy files (I ... old 40 GB HDD to the new one. ... offer to assist me install the new drives still stands I might be taking ...
    (microsoft.public.windowsxp.hardware)