Decided to buy a new A8N-SLI as a replacement and I'm replacing the chipset fan, but...

I forgot how I got the stock fan off. I has two little push-through
pins that I think I can break off...but....? Help and advice please?
.

Relevant Pages

  • Re: Mitsubishi VS-5043 - Raster Problems, 3 Curved RGB lines
    ... Many thanks jeff and jumpster the your advice. ... connectors on the yokes and resoldered the pins on all three yoke pcbs. ... Looks like I have to resolder the vertical IC 401, ...
    (sci.electronics.repair)
  • Re: Tech: EBD Switch Matrix
    ... may result in property damage, minor injury, serious injury or death. ... Follow advice at your own peril.] ... The header pins are not shorted together. ... Disconnected coin door connector and reran test - no change. ...
    (rec.games.pinball)
  • Re: THANKS GUYS
    ... have given me advice. ... pins several months ago. ... to continue and will surely buy a few more machines. ... Love the hobby and gather invaluable info here as well. ...
    (rec.games.pinball)
  • Re: Question for DataFlyer Owners
    ... Any advice where I could find one or are they common? ... >> when I connect a SCSI zip100 drive to it. ... > Pins 18..25 of the PC parallel port are all GND (signal ground), ... > cables connect all these pins together with one single wire. ...
    (comp.sys.amiga.hardware)
  • Re: Many thanks to Dave Lehmann - advice on soldering board for first time (J120 on TZ)
    ... In my case, I have a couple of burnt pins on separate 9&10 pin headers, so ... last night / this morning completed the job (full .156 header ... As for advice for newbs like myself - GO Slow. ... Heat up the little solder around the trace ...
    (rec.games.pinball)