Re: A8N-E SATA speed

On Sun, 28 Oct 2007 00:09:09 -0400, "Percival P. Cassidy"
<nobody@xxxxxxxxxxxx> wrote:

I have an A8N-E motherboard with the latest BIOS (1013, IIRC); it claims
to have onboard SATA capable of 3.0GB/sec. I recently added a Seagate
SATA drive that also claims to be capable of 3.0GB/sec., but in
WinXP+SP2 Hardware Manager the only available transfer modes are 1.5G
and PIO.

I installed the latest nForce drivers from the nVidia Web site, but
there has been no change in the displayed transfer speed options. When I
run the speed test, the sustained speed is little higher than that of an
old ATA100 drive in the same machine.

Why no 3.0GB/sec?
Two things.
Check on the Seagate site. Some of their drives come configured to
only run the interface at 1.5GB/sec 'out of the box', because of
compatibility problems,with some older interfaces. Tthere is a
software utility (and in a few cases a jumper), to configure the drive
to use the 3G/sec rate.
However the big one is that this is a limiting speed on the interface,
not a speed that will ever be achieved by a drive. At present the
fastest drives are still slower than the older 1.5GB/sec interface,
and even talking to the internale RAM buffer, you are unlikely to get
much over the old rate. Think of the rate, like a speed limit on a
motorway. Raising the limit to 300mph, won't mean that cars can
actually 'do' this rate...

Best Wishes

.

Relevant Pages

  • [2.6 patch] remove the documentation for the legacy CDROM drivers
    ... This patch removes the documentation for the removed legacy CDROM drivers. ... SC1200 WDT DRIVER ... LaTeX document on standardizing the CD-ROM programming interface. ... THIS DRIVER WILL WORK WITH THE CD-ROM DRIVES LISTED, ...
    (Linux-Kernel)
  • Re: WTB: Atari Hard Drive in UK
    ... I checked to see if its the same as my BBDP interface and ... > GAL swapped in the STE but Atari did this without charge. ... >>> definitely want an ACSI drive, ... >> interfaces (i.e. for non-SCSI drives) and ASCI to SCSI interfaces. ...
    (comp.sys.atari.st)
  • Re: Home brew Z80 CP/M computer
    ... any skill or experience level builder can successfully build their ... available before too long and will provide an IDE interface for HDs, ... you do not need any real drives to use the N8VEM SBC. ...
    (comp.os.cpm)
  • Re: Does anyone need IDEfile PCBs?
    ... ProFile interface between an Apple II and an IDE drive when there ... IIRC the Profile was only supported by UCSD Pascal, while most people in EU ran DOS 3.3 and most in US had ProDOS. ... The IDEfile protocol converter has been designed for the Apple III and Lisa. ... There were no alternatives to the Profile and Widget drives. ...
    (comp.sys.apple2)
  • Re: SwiftDisk
    ... Which version of the Sixword interface is it? ... I believe the format is 9 sector, and not ten as for +D, and uses a pretty ... I never had problems with format on a variety of drives, ... >I recently purchased a Swiftdisk interface and disk drive, ...
    (comp.sys.sinclair)