Re: P5GDC-V Deluxe build

Ihatefishsauce wrote:
I would like to know now how to pin out my audio from the case as
follows:

Cable from case:

Black = Ground
Red 2 = Mic in
yellow 2 = mic-power
white 2 = R-ret
yellow 1 = R-out
white 1 = L-out
red 1 = L-ret

On the motherboard as follows:
Azalia Compliant pin definition:
-------------------------------------------------------------
Top pins, L to R: GND, | Presence#, |
Sense1_RETUR, | (pin missing), |
Sense2_RETUR
-------------------------------------------------------------
R, | Sense_Send |
Port2-L
-------------------------------------------------------------

for the Legacy AC'97 Compliant pin definition:

Top Pins, L to R:
_
-------------------------------------------------------------
Top pins, L to R: AGND | NC |
NC | (pin missing), | NC
-------------------------------------------------------------
R, | NC | Line-Out-L
-------------------------------------------------------------

I hope my ascii diagarm doesn't get messed up when I post this. My
question is which header do I use based on the above case audio
cables and where do I plug what? Thanks again.



The seven wires you show for your computer case, are "AC'97" compatible.
I have yet to see a computer case with HDaudio/Azalia wiring, so they're
all the same as far as I know.

You want to use the Legacy AC'97 definition of your motherboard header.
You set the BIOS to indicate that you are using the Legacy mode.

The CODEC chip is still HDaudio, so that part doesn't change. The chip
still functions in HDaudio fashion. The BIOS declaration just affects
the computer doing the right thing with the header wiring.

The header only has five functional pins. Four of the header pins are
"NC" or "No Connect".

Your cable has seven wires. Two wires will not be used. The "L-Ret" and
"R-Ret" will not be used. The remaining five wires connect as follows:

AGND ===> Black = Ground
MIC2 ===> Red 2 = Mic in
MICPWR ===> yellow 2 = mic-power
Line_Out_R ===> yellow 1 = R-out
Line_Out_L ===> white 1 = L-out

HTH,
Paul

.

Relevant Pages

  • Re: Can an ATA100 pin be cut so ATA133 cables will work?
    ... They often rely on the red stripe on the cable for pin ... On the header, it is the right side of the bottom row. ... Just wish someone had applied that logic to floppy drive cables. ...
    (comp.os.linux.hardware)
  • Re: Looking for the "Unipod directory in Apps"
    ... in) from header socket to similar socket on an ex SCSI external box. ... Installed 80Gb IDE drive and partitioned into 3 approx equal chunks. ... If you add the length of the cables inside the RPC, ... Syncopath compares a byte-count of both drives and, ...
    (comp.sys.acorn.hardware)
  • Re: Anyone active on APRS?
    ... Chronos wrote: ... the old "let's put an RS232 header on the board and make the ... backplane cables nigh impossible to get hold of" trick. ...
    (uk.radio.amateur)
  • Re: internal serial cable for COM2 - Asus AV8 Deluxe
    ... AT-EVEREX-INTEL pinout (likely the Asus way too) ... If using a DTK cable on an INTEL header, ... on interfaces and cables here: ...
    (alt.comp.periphs.mainboard.asus)