Re: p4p 800 boot

I have changed the power supply with a sure one and no light is not correct.
I have the green led on the board and a correct +5VSB.
I checked the connectors and wires but I have no boot.
What can I control?


"Paul" <nospam@xxxxxxxxxx> ha scritto nel messaggio
news:esqan4$61j$1@xxxxxxxxxxx
STEFANO BOSCOLO wrote:
I had a PC with a p4p 800 SE from a friend.
The computer was working in another house, now we can't have a boot.
I mean no fan and no light.
I have searched on the Internet and it seems to be usual for this MB.
Any idea?

"no fan and no light" = check the power supply.

Make sure the front panel wiring (front power switch)
is still connected to the PANEL header.

Check for the presence of +5VSB on the 20 pin power connector.
You can even do this, by looking for a green LED on the motherboard.
That LED is connected to +5VSB. If the LED is not lit, when the PSU switch
is flipped on, on the back of the computer, then the power supply is
bad, or the power supply is shorting out on the +5VSB.

Paul




.

Relevant Pages

  • Re: fan
    ... "Those are my principles. ... I explained WHY the M/B connectors may not be working. ... Molex connector from your PSU and still attach a lead to the fan header ...
    (microsoft.public.windowsxp.hardware)
  • Re: ASUS P5B DELUXE WITH SONATA 11 CASE
    ... "Fan Only" 4 pin Molex connectors. ... circuit are controlled be a temp sensor in the PSU. ... plug it into a "Fan Only" connector. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: What is involved in swapping a power source
    ... drives may need to released and temporarily moved forwards. ... Temporarily secure fan blades whilst "blowing out dust-bunnies" using ... Carefully disconnect the power supply connectors from the hard drive, ... make a note of where they are and disconnect them. ...
    (microsoft.public.windowsxp.hardware)
  • Re: A basic fan connector question
    ... with the system fan. ... I have tried putting the 2-pin plug on to pins 1-2, ... do a bit of soldering or altering of the cable and/or connectors? ... If it is then the connector will be PWM Fan Connectors. ...
    (comp.sys.intel)
  • Re: fan
    ... But the O/P is asking about the M/B connectors - not molex ... I explained WHY the M/B connectors may not be working. ... Microsoft MVP Windows Shell/User ... Molex connector from your PSU and still attach a lead to the fan header so ...
    (microsoft.public.windowsxp.hardware)