K8N No Post, No Beeps

My computer (ASUS K8N, Athlon64 3000+, 1GB Crucial) locked up for no
apparent reason today. On the next boot, the fans spun but I got no
beeps and no video (no POST or any screen).

I removed the memory to test the system's capacity to beep, and it
didn't beep when powered on. The system has always given me the normal
boot-up single beep, so I know the speaker works.

I pulled the processor, and everything looked okay.

Really stuck on my next move. What would you check?

Thanks

-tom

.

Relevant Pages

  • Re: A8N5X Beep code follow up
    ... Memory has been reseated in RAM slots, all connections are good--video card properly seated in its slot, and is secure. ... Any thoughts/comments/suggestions before purchasing replacement video card? ... Tested both memory modules in slot B1, same beep code--however, either stick in slot A1, and both in A1/A2 work just fine. ... Cons: The beep code is wrong -- gives video error beeps for a memory error. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Random reboots with M2N-E (even worse now)
    ... error that happens during the reboot, ... I've known memory beeps to be 3 short ones, but this is on the Award ... When I couldn't find the 2.1V setting in the BIOS to adjust the memory ... you should get the same beep code. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Random reboots with M2N-E (even worse now)
    ... One long beep, two short beeps is memory, not video. ... I have also read multiple places that OCZ memory does not work very well in the ASUS AM2 motherboards. ... Getting random reboots on my M2N-E ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Dell Power-on Self Test Audio Error Codes
    ... When it attempts to start, it gives a short beep, pauses, gives three ... Why does my computer generate a 1-3-2 memory beep code error after ... Disconnect the power cable and drain the "flea" power. ... and immediately go into the CMOS setup program. ...
    (sci.electronics.repair)
  • Re: Dell Power-on Self Test Audio Error Codes
    ... When it attempts to start, it gives a short beep, pauses, gives three ... Why does my computer generate a 1-3-2 memory beep code error after ... Disconnect the power cable and drain the "flea" power. ... Why a computer may give a 1-3-2 memory beep code after upgrading the ...
    (sci.electronics.repair)