Re: Installing K6-2 333MHZ on TX97-XE from k6 166MHZ
- From: "Liquid" <liquidtek555@xxxxxxxxx>
- Date: 13 Jul 2006 02:12:19 -0700
I answered most of my own question I got it to work at stock speeds
from searching the web and found undocumented settings. Yay me. Gonna
put on some artic silver 5 and overclock it a bit should go well being
such a low voltage chip.
As far as overclocking go my most important question. Paul or
hopefully someone else can help me on this one. Does the FSB setting
just effect the memory which is fast and newer or the cards and hard
drives also on this board? I think I read yes (cards and hd) but it's
not like modern BIOS where you do it thru software just done via
jumper.
Like on my newer A7V333 the bios and FSB upper setting goes up with pci
bus. I can see it in the bios. Sucks to have that ratio and not
individually might make me choose less stable oc friendly board in the
future.
Hopefully somebody can shed some light on this issue of the FSB on this
board.
Thanks for any and all info appreciated.
Dan
Liquid wrote:
Hello fellow ASUSers,
I'm trying to find the settings for a k6-2 333 for TX97-XE revision
3.03 says it is supported but no documentation for settings. So I need
settings for vcore for 2.2 and multiplier 5 both undocumented and tech
support had only the info I had from site so don't waste time looking
at ASUS site for manual to answer this question. Closest that is
documented is 2.1 or 2.5 vcore and 4.5 multiplier.
www.cpu-world.com says this chips voltage is 2.2 +/- .1 volt.
Using this box as a firewall with IPcop pretty cool but snort uses up a
lot of CPU resources when both interfaces are watched green and red
gets maxed out and internet speed will be doubling free of charge
sometime in near? future for Comcast users instead of price cut to
compete with DSL.
Well, thanks in advance to any replies or info that could help me.
Best Regards
Dan aka Liquid/CyberWorld
.
- Follow-Ups:
- References:
- Installing K6-2 333MHZ on TX97-XE from k6 166MHZ
- From: Liquid
- Installing K6-2 333MHZ on TX97-XE from k6 166MHZ
- Prev by Date: Re: Where's this message coming from?
- Next by Date: A8N-VM CSM Video Problems
- Previous by thread: Installing K6-2 333MHZ on TX97-XE from k6 166MHZ
- Next by thread: Re: Installing K6-2 333MHZ on TX97-XE from k6 166MHZ
- Index(es):
Relevant Pages
|
