ASUS P4V800D-X SATA Install problem

I've just put together a config based on the above motherboard. I've
installed a 2.6GHz P4 processor and 256MB of DDR and the POST works fine. I
have installed a MAXTOR 250Gig SATA-II drived jumpered for 150Gb/s
operation.

In the BIOS I have SATA - IDE enabled (ie no RAID). The Bios correctly
reports a 250G Maxtor during POST as drive Master 3.

When I then try to install XP from my XPSP1 CD, the drive is reported as
being 131Gb. How do UI get XP to recognise the correct size of the drive?

TIA

STeve


.

Relevant Pages

  • Re: Windows will not boot up after power outtage.
    ... don't select tab, F8, then Maxtor. ... BIOS is not installed". ... next prompt says, NTLDR i missing. ... Press CTRL+ALT= DEL to install. ...
    (microsoft.public.windowsxp.general)
  • Hard Drive Problems
    ... BIOS by not by Windows XP Install CD (message to the effect that it can't ... Maxtor MaxBlast3 CD. ...
    (microsoft.public.windowsxp.hardware)
  • Hard Drive Problems
    ... BIOS by not by Windows XP Install CD (message to the effect that it can't ... Maxtor MaxBlast3 CD. ...
    (microsoft.public.windowsxp.hardware)
  • Re: ASUS P4V800D-X SATA Install problem
    ... (translations from/to FI not always accurate ... I have installed a MAXTOR 250Gig SATA-II drived jumpered for 150Gb/s ... reports a 250G Maxtor during POST as drive Master 3. ... When I then try to install XP from my XPSP1 CD, ...
    (alt.comp.periphs.mainboard.asus)
  • Re: ASUS P4V800D-X SATA Install problem
    ... I have installed a MAXTOR 250Gig SATA-II drived jumpered for 150Gb/s ... In the BIOS I have SATA - IDE enabled. ... reports a 250G Maxtor during POST as drive Master 3. ... When I then try to install XP from my XPSP1 CD, ...
    (alt.comp.periphs.mainboard.asus)