Re: Broken SATA connector

The Seabat wrote:
On Tue, 22 Apr 2008 09:29:51 -0400, "Blattus Slafaly ? (3) ¼ :)"
<boobooililililil@xxxxxxxxxxxxxx> wrote:

<<<snip>>>

Put a new connector on it. http://www.satagear.com/SATA_Connectors.html

So you want him to tear the unit apart, pay $20 for the two connectors
plus $10 shipping ($30 total) and then try and solder all those wires
onto the pins?? Instead of just buying a new unit for about $30 or
better yet, using the glue as has been suggested?? Your logic does not
compute!

Glue a connector? That IS retarded.

--
Blattus Slafaly ? 3 :) 7/8
.

Relevant Pages

  • Re: Soldering bypass caps to QFP possible?
    ... and that's also where the lone bypass cap dwelleth. ... the power pins. ... Make a tiny PCB that has bypass caps, and glue it on top of the chip, ... and drop down ground and vcc wires. ...
    (sci.electronics.design)
  • Re: Broken SATA connector
    ... plus $10 shipping and then try and solder all those wires ... onto the pins?? ... Instead of just buying a new unit for about $30 or ... Glue a connector? ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Broken SATA connector
    ... plus $10 shipping and then try and solder all those wires ... onto the pins?? ... Glue a connector? ... Cheaper than buying a new drive..... ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: pin nails holding power (ref: to Norm as well)
    ... Using a Polyvinyl Acetate glue ... ply the clamping pressure will add much to the strength of the joint. ... In reality most clamps will be set to 300-400 ... Naturally the brads will hold a bit better than pins. ...
    (rec.woodworking)
  • Eight Ball Champ Casualty - My first
    ... I've done difficult 80's pins like HS, ... The PF was nasty as it had full PF mylar and was lifting as ... In fact, with the glue left, the PF looked like it was CC. ... I think the PF is ruined and I'm sick about ...
    (rec.games.pinball)
Loading