Re: Silly Question
- From: Paul <nospam@xxxxxxxxxx>
- Date: Wed, 23 Jan 2008 19:58:11 -0500
Daave wrote:
Peter wrote:In article <DNqdnaMqA4vHDwranZ2dnUVZ_uGknZ2d@xxxxxxxxxxx>,
jrweiss98155NOSPAM@xxxxxxxxxxxxxxxxxx says...
"Daave" <dcwashNOSPAM@xxxxxxxxxxxxxxxxxxxx> wrote...However, a switch should work, though. If the DSL modem's networkI have one PC hooked up to a DSL modem. I want to temporarilyYou will likely need a router.
connect another PC to my DSL connection. Would an Ethernet switch
work for this, or do I need a router?
Other options are to temporarily disconnect the first PC, or to use
the Internet Connection Sharing function of Windows.
I recommend the router. It's relatively cheap, and much easier to
configure than ICS.
cable
goes to the switch's input socket, then the 2 computers could connect
to
separate ports on the switch and it should work.
What you may have to do is:
Turn off DSL modem and completely unplug it.
Plug net cable that currently goes from DSL to computer into the input
socket of the switch instead.
Plug in and turn on DSL modem
Turn on switch.
This should allow the MAC address on the switch to be freshly picked
up
as the primary MAC address by the DSL modem.
I knew a router would definitely work, but I was wondering why an
Ethernet switch wouldn't work, too. So, assuming this method would work,
would there be any disadvantages to it?
Does the DSL modem have a make and model number ?
What does the manual say about protocols used ?
My DSL modem has only one WAN connector and it carries PPPOE
(point to point protocol over Ethernet). To use it, I either
connect to a router that terminates PPPOE, or I install some
software on the computer (I did that years ago, when I was
using a Mac). Since your device has two interfaces, that implies
it is quite different. For example, if only one interface
can be used at a time, then it could use PPPOE or equivalent.
If both interfaces can be used simultaneously, then ordinary
packets would be expected.
I'm willing to bet the user manual probably has a few words on
the subject. Even a detailed spec *** might hint at what to
expect.
Paul
.
- Follow-Ups:
- Re: Silly Question
- From: Daave
- Re: Silly Question
- References:
- Silly Question
- From: Daave
- Re: Silly Question
- From: John Weiss
- Re: Silly Question
- From: Peter
- Re: Silly Question
- From: Daave
- Silly Question
- Prev by Date: Re: Silly Question
- Next by Date: Re: new heat sink needed?
- Previous by thread: Re: Silly Question
- Next by thread: Re: Silly Question
- Index(es):