Re: FREE AMD flash drive with Athlon LE CPU purchase
"OhioGuy" <none@xxxxxxxx> wrote:
It's AMD's latest offering on the AM2 platform.
Specs:
45 Watts (compared to the 89 Watts of earlier models)
That's nice.
2.44 GHz (should overclock to ~ 2.7 GHz or higher)
1 MB L2 cache
1.25 Volts
Retail boxed version, with heatsink, fan, & 3 year warranty
It's a single core,
There are dual core CPUs for AM2 mainboards.
but if you're like me & still using something older,
Depends on how much older, and how much cheaper dual core CPUs
become.
it represents a great way to upgrade to an AM2 or AM2+ board.
For $50 with the 512 MB flash drive, yeah, depending on what your
current system is.
Good luck and have fun (but don't expect "a mean Vista machine that
can do about all you want done with ease" like the review says).
.
Relevant Pages
- Re: H2 at 10,000 psi
... Getting the heatsink to have a 25 degree drop is not in any manner trivial at ten watts. ... It is utterly trivial for a Peltier device to end up HEATING rather than cooling. ... The fatal flaw in low COP thermoelectric technology is that MUCH MORE HEAT HAS TO GO THROUGH THE HEATSINK THAN THE COOLING WATTS. ...
(sci.energy.hydrogen) - Re: Suggestions on cutting energy bill --
... Is there a good meter I can plug in between an appliance to the wall to ... watts in my ceiling fan costs me about $3.30 a month to run where if I ... $10/month right there a month on electricity even though the investment ...
(alt.home.repair) - Re: Too many radios?
... dremel and cut into the fins so the fan or fans will be inset and out of ... I wish it had another mid power setting at 25 watts. ... The 667 has a few fins pushed over to grab the course pitch screws in the ... That amp is strapped and will draw a good 90 amps, about 1,250 DC watts! ...
(rec.radio.cb) - Re: new heat sink needed?
... The 3200 runs at 38 deg and has a heat load of 67 watts the 4200 is rated at 89 watts. ... Will my current heatsink be enough for this CPU? ... Say the room temperature is 25C. ...
(alt.comp.hardware.pc-homebuilt) - Re: 4-pin pwm fan.
... a resistor on the 12 volt line, but that would require either a three ... plus at 1/588 watts, ... If you experiment with adding a diode in the line you cut with the cathode towards the motherboard, Your resistor to ground (on the fan side of the diode) should set the minimum fan speed but the motherboard could still increase it as required. ...
(sci.electronics.repair) |
|
