Is this PSU compatible with my motherboard?

Hello. I'm looking at a Corsair CMPSU-520HX PSU

http://www.mwave.com/mwave/viewspec.hmx?scriteria=BA24129

My motherboard has a 20-pin power connector, the PSU has a 24-pin
connector. In the Corsair manual it says:

"The 24-pin main power connector has a detachable 4-pin connector.
This 4-pin connector is not a P4 or ATX 12V connector."

Am I right to assume that I can detach the 4-pin connector, which
will make it a 20-pin that will work with my motherboard?

I have an AOpen AX4SPE motherboard w/ a P4 3.0ghz cpu.
.

Relevant Pages

  • DOCS for BUGG-POWER external power supply IIGS/IIe/II+
    ... Univ. of New Mexico-Gallup IBM POWER SUPPLY IIGS INSTALLATION PROCEDURE ... Molex-7 connector on the motherboard. ... voltages will normally be lower than the target values. ...
    (comp.sys.apple2)
  • Building Skybucks Dream PC, Early/Preemptive Report :) was Re: How to connect 7-in-1 floppyd
    ... Your 1x4 connector on the cardreader, ... I wasn't sure what to do since the USB ports/header on my motherboard ... (I actually switch to vga to connect my old computer lol... ...
    (alt.comp.periphs.mainboard.asus)
  • Re: problem with Dell laptop
    ... I'm certain it's the correct adaptor for that model of laptop but it just stays on battery power when connected to the mains, ... I'm thinking that maybe it's taken a knock and something is busted inside, like where the power socket connects to the motherboard. ... Re-seating the connector flush with the motherboard with some additional physical support such as Araldite or hot melt glue. ... If mangled you need to remove the mangled bits, remove a few mm of coating from the ends of the remaining tracks on the motherboard and solder some link wires from these points to the contacts on the power connector, taking care not to heat the tracks for too long or more will lift off. ...
    (uk.comp.homebuilt)
  • Re: Trying to get 3-way SLI to work
    ... I can try a different CPU if you think it would be ... I have not had a dead motherboard that seemed to work but ... and a 1x4 connector on the end. ... is a PCI Port 80 debug card. ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Rebuilding an old computer
    ... So investing in a FSB1066 motherboard at this point, ... assumes you'll be buying a video card separately. ... The board uses a 24 pin power connector (and new power supplies have a 20+4 ...
    (microsoft.public.windowsxp.general)