Re: Can Low Voltage kill a power supply?

Sjouke Burry <burrynulnulfour@xxxxxxxxxxxxxxxxxx> wrote:
Ray Cassick (Home) wrote:
"Rod Speed" <rod.speed.aaa@xxxxxxxxx> wrote in message
news:4kp3plFcutpeU1@xxxxxxxxxxxxxxxxx

n33ck0@xxxxxxxxx wrote:


Hi, everybody. 2 weeks ago ther was a case of low voltage in the
neighborhood. After calling the utility co. it was determined there
was too much demand on the grid. not anything specific in the
house. So here is my question can a low voltage situation kill a computer
power supply.

A properly designed power supply should shut down in that situation.

A badly designed power supply can be killed in that situation.



Just a bit curious as to how you think a power supply can be damaged
by a low voltage situation?

Since all the regulation in a PS is designed to convert AC to DC and
then regulate those output voltages down to useable levels within a
specified tolerance I don't see how a low voltage could result in a
dead PS. I DO see how it can cause flakiness on the low voltage side
since all outputs are based upon a properly regulated input voltage
tolerance, but all that should result from a low input voltage is
proportionally low output voltages. Personally I would think that most of the damage
would have been
caused by a backlash of higher voltage that can often occur after
low voltage situations. This higher than normal voltage inrush could
happen faster than the regulators are prepared to handle and cause a
very quick spike to get through the filters and fry the lower
voltage side of the regulation circuit perhaps.

A switching supply will draw a bigger current from the
mains to compensate for less voltage, the output voltage
wont drop ,power wont drop, so you need more current.
When input is low enough ,and current becomes big enough,
either the safety cuts in, or the supply blows.

That increased current isnt what kills a badly designed supply.

The only current that goes up is from the mains and the diodes
that rectify the mains arent that marginal current capacity wise.

What actually kills a poorly designed power supply in that
situation is the inevitable associated mains surges as loads
trip out due to the low mains voltage, particularly motor loads.

And that depends on the quality of the supply.


.

Relevant Pages

  • Re: Can Low Voltage kill a power supply?
    ... So here is my question can a low voltage situation kill a ... that rectify the mains arent that marginal current capacity wise. ... no. Surge suppression of the type you're arguing is relatively simple and fairly static from design to design. ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Can Low Voltage kill a power supply?
    ... low voltage situation kill a computer power supply. ... and fairly static from design to design. ... where stupid cost cutting sees inadequate surge suppression. ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Can Low Voltage kill a power supply?
    ... So here is my question can a low voltage situation kill a computer power ... Since all the regulation in a PS is designed to convert AC to DC and then ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Can Low Voltage kill a power supply?
    ... So here is my question can a low voltage situation kill a ... proportionally low output voltages. ... that rectify the mains arent that marginal current capacity wise. ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Connection in exterior concrete pad
    ... Could you, possibly, consider running "low voltage" power ... running 70m or so of cable we are looking at a fair voltage drop. ... is Low Voltage would need to check my regs, ... This sort of wiring is commune on building sites for portable power ...
    (comp.arch.embedded)