problem with Masscool and AMD 3200+
- From: dave xnet <davexnet02NO@xxxxxxxxxxxxx>
- Date: Fri, 21 Jul 2006 17:00:48 -0700
Hello,
never installed one of these types of coolers before.
I put in the grease placed the cooler over the cpu,
locked the smaller of the clips over the supporter,
then went to the reverse side, pushed down and locked the
larger of the two. However, I am unable to complete the
third step, pushing down on the black clip to actually
tighten the thing. It just wont budge. Step 8 here:
http://www.masscool.com/masscool/socket_754939940.asp
Have I got the whole thing 180 degrees te wrong way
round? Looks like it goes on either way.
On top of that, even though I then undid the two clips
I can not get the device off of the cpu. It seems to have formed
a seal with the grease - I'm afraid to pull it too hard in case the
cpu is damaged.
I thought this design was supposed to make things easier -
Help!
Thanks,
Dave
.
- Follow-Ups:
- Re: problem with Masscool and AMD 3200+
- From: dave xnet
- Re: problem with Masscool and AMD 3200+
- Prev by Date: Re: Desperate! What's the best way to partition 160GB hard disk
- Next by Date: Re: Desperate! What's the best way to partition 160GB hard disk
- Previous by thread: testing power supplies
- Next by thread: Re: problem with Masscool and AMD 3200+
- Index(es):
Relevant Pages
|