Cannot find dvd drive on 2nd channel
I have just installed a Gigabyte GA-81945P pro motherboard. If I
install the IDE HD on 1st channel (red) and DVD drive on 2nd channel
(green) - the hd shows up ok but dvd drive is not shown anywhere.
If I put HD on 2nd channel (greenP) and DVD-Drive on 1st channel (red),
the dvd is picked up as master drive and hd is picked up as part of
Raid as IDE0 and attempts to go into windows from the hd and crashes.
Why cant I see the DVD-drive on 2nd channel (green)?
- Re: No Wondows XP boot with CD slaves connected
... I had a m/b that if I used the sata, I lost an IDE. ... and a 100MB Zip Drive on the 4th channel. ... After doing a Repair install of XP and installing the MB ...
- Re: New Hd Install - No Udma Support, Dma 2 Only
... My boot drive, a 20 gb maxtor fireball, functions fine in UDMA 5. ... The 20 gb drive under the primary ide channel as a master, ... I don't want to do a clean install of XP because of the time involved ...
- Re: OTA reception: 35 miles SW from Chicago: should I get a cool, new design antenna or standard ant
... but lacking at channel 2 frequencies. ... I then installed the Dish Network hardware and always considered my antenna ... I think you can get good reception from the Winegard hardware as described ... install and recommend Winegard products. ...
- Re: MCE2005 & ASUS P7131 mycinema tunner
... the info of the selected channel, but the Tv picture does not change. ... An ideas how to have both - RF and S-Video selectable from MCE? ... The RF input, when I had it, showed a Tv picture with a lot of 'grain'. ... Would I improve the Tv picture if I upgrade or install another decoder? ...
- No Wondows XP boot with CD slaves connected
... I replaced my Soyo P41S motherboard, which had 4 IDE channels, with an ASUS ... My original setup contained 5 IDE devices - WD160 GB HDD on the primary channel, ... since I didn't use the ZIP drive all that much, I didn't install it in this ... the machine won't boot up into Windows with the Sony CD reader ...