Re: local Boston resource question

On Mar 25, 9:40 am, Boston Coffee Party <BostonCoffeePa...@xxxxxxxxx>
wrote:
? What you are describing is exactly what the "test" in the link does
- using a styrofoam cup as the small vessel, whilst recording the temp
during the shot. Not scientific, but does the job, and it isn't
designed to measure the pressure (you need a Scace device for that).

Thus to my point, am I not getting a low brew temp if I am getting
water that is around ~80 degrees in the vessel? Secondly, that is why
I posted on here to see if anyone was local with equipment like a
scale device and the knowledge to adjust the pressure stat or anything
else that needs adjustment rather than sending the machine on a fun
filled journey inside a few cardboard boxes. I am not opposed to
sending it out, but I thought that perhaps someone would know a good
resource here in MA.

Thank you,
Adam

pressure = temperature.
.

Relevant Pages

  • Re: local Boston resource question
    ... - using a styrofoam cup as the small vessel, ... designed to measure the pressure (you need a Scace device for that). ... am I not getting a low brew temp if I am getting ... else that needs adjustment rather than sending the machine on a fun ...
    (alt.coffee)
  • Re: local Boston resource question
    ... than simply collecting the water flow in a small vessel and reading ... - using a styrofoam cup as the small vessel, whilst recording the temp during the shot. ... Not scientific, but does the job, and it isn't designed to measure the pressure. ...
    (alt.coffee)
  • Re: continuation of pressure vs temp in a PIDed HX
    ... interested in steam boiler temperature per se, ... The steam boiler temp IS one step removed ... trial and error that this gives me the circa 95C BREW temperature that I'm ... But since it is the hot water that gives rise to the steam pressure, ...
    (alt.coffee)
  • a PIDed HX
    ... I, too, could frankly care less about steam temp. ... interested in steam boiler temperature per se, ... more useful a figure than boiler pressure (they are both equally good or bad ... to accurately control pressure during steaming and it's no longer ...
    (alt.coffee)
  • Re: Molecular oscillation (vibrations?) without heat exchange?
    ... The vessel will experience mass loss in accordance ... Probably the heat is best put use into the drive where a steamengine ... and waterturbine pump water over a plate vaporiser. ... The highpressured steam will try to level heat and pressure, ...
    (sci.physics)