Re: Should head bolts be lubed or un-lubed? What about thread sealer

From: "qslim" <Suckers@suckersdotcom>
Date: Fri, 29 Jun 2007 21:13:40 -0400

All Toyota factory engine manuals I've ever seen call for a light coat of
oil on the bolts, I've never seen them call for thread sealer.

.

Prev by Date: Re: O2 Sensor Problem Again
Next by Date: Re: Hmmm....going on vacation, not quite enough room for the dog...
Previous by thread: Hmmm....going on vacation, not quite enough room for the dog...
Next by thread: OT - Democrats suck but better than Republicans according to poll
Index(es):
- Date
- Thread

Relevant Pages

Re: Short Ride Report
... and put it over the end of the crank. ... slick it with oil before sliding the crank seal over the crank shaft. ... remove the bolts, put them in the cardboard's corresponding holes. ... The clutch push lever was the culprit. ...
(rec.motorcycles.dirt)
Re: Merc A class
... When they're £30 and the dealer is £41, and doesn't snap the bolts in your timing belt cover and not tell you, or uses oil filters without non-return valves when you've provided an OEM spec part, or put whatever the oil they had around in the car when I provided a gallon of Mobil 1 (yes. ... the dealer charges a book time usually. ... If they spend 7 hours arguing with a rotten lower arm bolt and the book time says 2.5 hours, I pay 2.5 hours - and I can legitimately feel 'wronged' if they've broken something under the car. ... Whereas the backstreet lot will charge the time it took, AND feel wronged when you ask why their trained monkey not only angle-ground the bolts off, but also a chunk out of my front subframe, ...
(uk.rec.cars.misc)
Re: Chainring bolts
... which led to my discovery that the bolts were loose. ... Loctite is a Bad Idea for this application. ... Phil Wood Tenacious Oil for this. ... wrench goes to tightening the fastener, ...
(rec.bicycles.tech)
Re: Sump Gaskett
... smoke bellowing out ... Possibly not as bad as it sounds - when mine went the oil dripped directly onto the exhaust manifold. ... Mine was retightened (and a couple of 'wrong size' bolts replaced) and the smoke/drip went away. ... "gunk" " if you could just lossen the bolts, squeeze some gunk into the gap and then tighten them up again. ...
(uk.rec.cars.maintenance)
Re: e34 95 525i oil leak behind oil filter cup housing
... filter cup. ... thats where the oil is coming from. ... Your oil leak is the result of one or both o-ring on the end plugs age- ... bolts, 2 altenator bolts and 2 power steering pump bolts also. ...
(alt.autos.bmw)