Re: vibration in steering wheel and floor?

Do this:

Raise the car on a hoist maybe a foot off the ground. Start the engine,
put the car in gear and let it idle. One of the front wheels will spin,
the other may require a hand push to get it going.


This could prove to be a bit difficult with a 5-speed.


.

Relevant Pages

  • Re: rec.autos.makers.chrysler FAQ, Part 4/6
    ... If your antifreeze was just changed and your car started to overheat, ... Idle speed jumps OR Intermittent idle speed problems ... 2.5L engine knocks/ticks; poor cold idle ... Later I found a 6-way connector was loose. ...
    (rec.autos.makers.chrysler)
  • Re: French politics
    ... Even my wife's Corolla has a very clean engine compartment. ... trying to jam it into 2nd gear. ... Ain't it fun to repair a transmission? ... The thing I disliked was removing it from the car and reinstalling it, ...
    (sci.electronics.design)
  • Re: French politics
    ... Even my wife's Corolla has a very clean engine compartment. ... The car would do ... This meant 1st gear was also lost a little ... and the tangs on the shift fork that fit in the gear to ...
    (sci.electronics.design)
  • Re: 69 Olds 442 Idle Problem
    ... too lean for an old car at idle. ... but in the fall decided a engine rebuild was in order. ... stock Quadrjet and two Holley carbs, ...
    (rec.crafts.metalworking)
  • Re: First cars: Would you want to own it again?
    ... My first car was bought in 1966, and it was a 1957, one owner from new, ... the incredibly sloppy gear change (the gear knob travel across ... the cylinder block so that the head gasket lasted on average 3 months. ... damage to the engine, and the rust was starting to get a hold in the double ...
    (uk.rec.cars.classic)