Re: 94 318i starts then immediately dies

Grizz <notme@xxxxxxxxxxx> wrote:
Got out my dremel and polished the terminal on the end of the
wire and the bottom of the nut, put it back together, and works perfectly again. Now I
have a spare DME relay in my toolkit in case it ever really fails ;-)

With the plating removed, it is apt to corrode again. Grease the thing up
with dielectric grease to prevent that. While you're at it, grease all the
connectors and relay bases up.
--scott
--
"C'est un Nagra. C'est suisse, et tres, tres precis."
.

Relevant Pages

  • Re: E30 diagnostic light (was E46 intermittent rear bulb failure)
    ... Check all the lamps, front and back, ... Thanks - I'll give this and the conductive grease suggestions a try. ... and go around pulling connectors and bulbs out ... C'est suisse, et tres, tres precis." ...
    (alt.autos.bmw)
  • Re: CV joint grease question
    ... When you change CV joint boots, I guess a lot of the old grease will be ... If the boot isn't torn... ... bother replacing it either. ... C'est suisse, et tres, tres precis." ...
    (rec.autos.tech)