1980 450sl does not run when warm
- From: Sam <dtsturgis@xxxxxxxxxx>
- Date: Thu, 29 May 2008 17:28:24 -0700 (PDT)
My 450sl starts fine and will run for about 5 minutes until it gets
warmed up. At that point it starts to run so lean that is stalls.
I have tested the fuel pressure 73psi (both warm and cold) and it is
within specs. I did a fuel volume test both when it was cold and warm
- ok. The pump and filter were replaced about 2, 000 miles ago.
I tested the control pressure from the warm up regulator to the fuel
distributor. Cold the pressure was 22 psi, warm 50 psi. Both within
the spec.
When I warm the car up and it will not run, if I hold the mass air
flow senser down a little enriching the mixture the car will run.
I have not tested the lambda control, but not sure that if it was
failing could lean the car out so much it would not run.
.
- Follow-Ups:
- Re: 1980 450sl does not run when warm
- From: Tiger
- Re: 1980 450sl does not run when warm
- Prev by Date: Re: 300SD Starter Question
- Next by Date: Re: 1980 450sl does not run when warm
- Previous by thread: 300E Fuel Distributor
- Next by thread: Re: 1980 450sl does not run when warm
- Index(es):
Relevant Pages
|