Re: Right Rear side light
On 2005-10-20 13:16:14 -0700, "John Simpson" <jasimp@xxxxxxxxxxxxx> said:
"Martin Joseph" <mercedes@xxxxxxxxxxxxxxxxxx> wrote in message
news:2005102012075275249%mercedes@xxxxxxxxxxxxxxxxxxxx
On 2005-10-18 03:19:34 -0700, "MrGrumpy" <dl@xxxxxxxxxxxxxxx> said:
Had the problem on a E300TD 1999, its caused by the light cluster
circuit
board 'cracking' thus pwr contact is not made to the bulb holder.
You can replace the circuit board yourself, its a simple operation.
If it's a crack in a trace, you can fix the circuit board instead.
Simply scrape off abit of insulation on both sides of the crack and
solder a bit of wire across it.
...... if you can find the crack!
Touche!
.
Relevant Pages
- Re: Amplifier Problem - ***SOLVED***
... I took voltage measurements, resistance measurements, tested ALL ... "The circuit board and all solder joints look ... The crack was ... emitter and the other end of it to the 3.3 ohm resistor. ...
(sci.electronics.repair) - Re: Toxic dangerous stuff your grandchildren wont miss
... Asbestos (insulation, siding, gaskets, etc.) ... Drainpipe sealant ... CRT X-ray shielding ... I already miss asbestos, there really is no good replacement for it in some applications (heat shield blankets for welding/soldering, etc) also low/no lead solder is way harder to work with than the old stuff. ...
(alt.home.repair) - Re: Solar charging: Real World
... enough insulation to make a connection and coat the whole thing with liquid electrical insulation when finished. ... I carry propane and electric gun solder equipment myself for the same purpose. ...
(rec.outdoors.rv-travel) - Re: Repairing a cracked pressure fitting
... I have no idea how the crack got ... What kind of fitting was this. ... taught me that JB Weld does not stick to brass. ... So I thought what the heck I'll just solder the crack. ...
(alt.coffee) - Re: Problems soldering 2.1 mm DC line socket
... CT> I recently bought a 2.1 mm DC line socket from Maplin ... CT> I tried to solder a lead to the inner contact, the plastic insulation ... CT> large iron. ... CT> melt the solder, so I reckon the plastic must have melted at less than ...
(sci.electronics.repair) |
|
