Re: Continued questions and comments



Why change something that's obviously working well - plug wires & coils if these give good mileage?
They can be changed independent of the sparkies.


The three coils are screwed onto the head; one of these screws split when I changed my car's plugs so I needed to drill it and use a small easyout to remove it. (That was fun.) Then replaced the 3 OEM headless screws with 4x30 mm Phillips head & washers from local hardware store. (Dealer told me the OEM screws aren't on the parts list and offered no alternative to buying a new head to get one!)

You'll need a ratchet extension for the plugs are about 6" down a tube.
Bosch 4301 Platinum 2 - to 19 ft lbs.

Also need a long, large screwdriver to loosen the clamp on the air intake - from the front and under the intake tubes.

Have fun.

.



Relevant Pages

  • Re: was my EK pin an SS or EM model?
    ... I only got the populated playfield- the head box was ... The switches are different between the two models also: EMs had tungsten switches to handle the high current load of driving coils directly. ... This was necessary to protect the electronic circuitry, some of which does not like reverse voltage. ...
    (rec.games.pinball)
  • Re: Fisher VCR model FVH919 snowy pix.
    ... I disassembled the head assembly and found that the coils were loose ... and slightly lifted in the ferrite tracks of the rotary transformer. ... A pg sensor is situated close to the lower drum ...
    (sci.electronics.repair)
  • Re: Making how-to videos for a friend of mine.
    ... The single biggest safety problem I have seen with greenhorns is not ... No coils. ... I know a woman who lost her little finger anyway...horse flipped it's head ...
    (rec.equestrian)
  • Re: gottlieb em drop targets JACKS OPEN
    ... drop targets are now fixed... ... There are four screws that hold the big coils in the assembly ... so the plunger goes down further lifting the reset bar higher .. ...
    (rec.games.pinball)
  • Re: Red & Ted Head Rebuild
    ... each head, label them! ... In my Rudy, all the coils were blue, and the ... It would be easier to label ... the eyes will not center. ...
    (rec.games.pinball)